1. During the redistribution process configured on RTA,some of the EIGRP routes,such as 10.1.1.0/24 and 10.2.2.0/24,are not being redistributed into the OSPF routing domain.Which two items could be a solution to this problem.(Choose two)
A. Change the metric-type to 2 in the redistribute command.
B. Configure the redistribute command under router eigrp 1 instead.
C. Change the EIGRP AS number from 100 to 1 in the redistribute command.
D. Add the subnets option to the redistribute command.
E. Change the metric to an EIGRP compatible metric value
( andwidth,delay,reliability,load,MTUS )in the redistribute command.
Answer: C D
2. Which command would display OSPF parameters such as filters,default metric,maximum paths,and number of areas configured on a router?
A. show ip protocol
B. show ip route
C. show ip ospf interface
E. show ip ospf
Answer: A
3. What is correct about the BGP synchronization command?(Choose two)
A. Synchronization must be enabled when implementing a multi-homed BGP connection to multiple ISPS.
B. If it is turned ON,a prefix learned from IBGP neighbor is valid only if a non-bgp (IGP) route exists for that prefix.
C. Synchronization is necessary when peering with an EBGP neighbor.
D. Synchronization improves BGP routing convergence.
E. Synchronization can be turned off if all the transit routers in an Autonomous system running full mesh IBGP.
Answer: B E
4. drag the appropriate IS-IS routing term to its correct definition.
收藏
推荐
评论(0条)
